Table of Contents
Advertisement
Quick Links
Trek® Lync
Supplement to owner's manual
This manual gives instructions on the use and
maintenance of the built-in lighting system on
the Trek Lync bicycle. It is a supplement to the
Trek Bicycle Owner's Manual.
This manual is written for the owner and does
not require mechanical experience. Some
maintenance should only be performed by the
dealer, and this manual tells you when that is.
Table of Contents
Foreword
"To See" light systems................................... i
Explanation Of The System ......................... 1
Tools Needed ................................................ 1
Battery Pack ................................................. 1
Dock .............................................................2
Lights ............................................................3
Control Panel ............................................... 3
Wires ............................................................3
Battery Indicator Lights ................................. 4
Recharging The Battery .............................. 4
Important:
The Lithium Ion battery should be fully
recharged before your first use, and before
any extended use.
"To See" light system
The lighting system on the Lync is a "To See"
system, intended to work as a head light
in low-visibility situations. The high-output
LEDs (Light Emitting Diodes) provide a bright
550 lumens headlight in a focused pattern to
illuminate the road ahead. The taillights (two)
are 3 lumens each.
This type of light meets lighting requirements
in most areas. Check with local authorities for
the requirements in your area.
The other type of light system, "To Be Seen"
lights, provide a wide beam in a dispersed
pattern so that the light is visible from a wider
angle. For best results, use both types of lights.
WARNING: A bicycle without
correct lights and reflectors might be
difficult for other people to see, and
you might not be able to see. If you
cannot see, or other people cannot see
you, you could have an accident. Make
sure your lights operate correctly
and that batteries are charged.
® Trek is a registered trademark of the Trek Bicycle Corporation
© Copyright Trek Bicycles 2014
J
i
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Trek Lync
Summary of Contents for Trek Lync
- Page 1 Supplement to owner’s manual This manual gives instructions on the use and maintenance of the built-in lighting system on the Trek Lync bicycle. It is a supplement to the Trek Bicycle Owner’s Manual. This manual is written for the owner and does not require mechanical experience.
-
Page 2: Tools Needed
• Short-circuiting the terminals With a full charge, the battery should power the Lync light system for about two hours forty minutes at full power, or five hours at low power. This time will vary according to battery condition, temperature, and other environmental factors. - Page 3 periods of time such as a week or more, store 5) are aligned for engagement. it at room temperature in a dry place. Avoid 3. Slide the battery pack along the dock until the latch locks the battery pack into place. moisture, or extreme hot or cold.
-
Page 4: Control Panel
Trek Lync Owner’s Manual Supplement Lights Control panel The headlight of the Lync system is in the The control panel is located under the top tube head tube (Figure 7). It can be switched to Off, of the frame, near the head tube (Figure 8). It High, or Low. - Page 5 1. Remove the battery from the dock. This section explains the very easy operation 2. Plug your computer to a power source. of the Lync lighting system. 3. Connect the battery pack to the computer with the supplied micro-USB cord. To access the port Switching the lights off, on, and on the battery pack, lift the cover (Figure 11).
Need help?
Do you have a question about the Lync and is the answer not in the manual?
Questions and answers