Table of Contents
Advertisement
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Chargers
Use your Black & Decker charger only to charge the
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
will resume operating.
Charge only at ambient temperatures between
10 °C and 40 °C.
Charging
#
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
1. On/off switch
2. Forward/reverse slider
3. Bit holder
Fig. A
4. Charger
5. Charger plug
6. Charger connector
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing a screwdriver bit (fig. B)
This tool uses screwdriver bits with a 6.35 mm (1/4")
hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (3).
To remove a bit, pull the bit shaft out of the bit holder (3).
Use
Warning! Let the tool work at its own pace. Do not overload.
Before first use, the battery must be charged for at least
16 hours.
Charging the battery (fig. A)
Place the tool on the charging base (6).
Insert the connector (5) into the charging base.
Plug in the charger (4).
Switch on at the mains.
Leave the tool connected to the charger for 7 - 8 hours.
The charger may hum and become warm while charging; this
is normal and does not indicate a problem.
Generally, a charging time of 4 hours will enable the tool to
operate at an effective power level for most tasks. However,
further charging for up to 8 hours could significantly increase
the run time, depending on the battery and charging
conditions.
Before using the tool, unplug the charger and disconnect
the tool from the charger.
Warning! Do not use the tool while it is connected to the
charger.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C.
ENGLISH
5
Advertisement
Table of Contents
