Led Introduction; Initial Connecting And Setting; Connect The Phone; Connect To Network - D-Link DPH-400S User Manual

1.6 LED introduction

Table 1 Programmable key LEDs for BLF
LED Status
Steady green
Slow blinking red
Steady red
Fast blinking red
Off
Table 2 Programmable key LEDs for Presence
LED Status
Steady green
Slow blinking red
Steady red
Fast blinking red
Off
Table 3 Power Indication LED
LED Status
Steady red
Fast Blinking red
Off

2 Initial connecting and Setting

2.1 Connect the phone

Connect to network

2.1.1
Step 1: Connect the IP Phone to the corporate IP telephony network. Before you
connect the phone to the network, please check if your network can work
normally.
You can do this in one of two ways, depending on how your workspace is set up.
Direct network connection—by this method, you need at least one available
Ethernet port in your workspace. Use the Ethernet cable in the package to
connect WAN port on the back of your phone to the Ethernet port in your
workspace. Since this VoIP Phone has router functionality, whether you have a
broadband router or not, you can make direct network connect. The following
two figures are for your reference.
Description
The object is in idle status.
The object is ringing.
The object is active.
The object is failed.
No subscribe.
Description
The object is online.
The object is ringing.
The object is active.
The object is failed.
No subscribe.
Description
Power on.
There is an incoming call.
Power off.