Winnebago Minnie Winnie Premier Owner's Manual page 87

3. Remove the top (4) pan head screws and top
(4) flat head screws at the top of the aluminum
trim.
4. Gently pull aluminum trim away from
sidewall with hand to disengage screw from
motor.
5. Using a flat-head screwdriver, push bottom of
slideout motor UP to disengage
(approximately 1/2" from base).
Repeat on opposite slideout motor.
SLIDEOUT ROOMS
Slideout Motor
(Located behind slideout wipe seal)
• Use a screwdriver to push slideout motor
UP (disengage).
• Ensure slideout motor is disengaged
approximately 1/2" from base.
6. Push slideout room in to travel position,
ensuring both sides are relatively even.
NOTE: Several people may be needed to push
the room in.
SECTION 10 –
10-5