Advertisement
Setting Up The System Programming Features:
Bank 1 Transmitter Channels:
1. Start with the system disarmed; turn the ignition switch to the on position; then press
and release the pushbutton valet/program switch 3 times.
Siren Chirps once and or Lights flash one time indicating the transmitter program mode
successfully entered. (See Owners Manual for transmitter programming.)
2. Turn the ignition switch off then on to access Bank 2 Keyless/Alarm feature selections.
1 short/1 long chirp when the key transitions off, followed by 1 short/1 long chirp when
the key is turned on indicates that you are in feature selection of bank 2.
3. Press the pushbutton switch 1 time to access the first selection as shown below. Use
the lock button of the transmitter to change the feature selection or press the push-
button to advance to the next selectable feature.
Bank 2
Feature
1 Chirp/Flash 2 Chirp/Flash 3 Chirp/Flash 4 Chirp/Flash
st
1
Door L/UL
1 Sec.
2
nd
Accy Lock
On
3
rd
Accy Unlock
All Doors
4
th
Passive Locks
Passive
th
5
Passive/Active Arm Passive
th
6
Siren/Horn
Both
th
7
Horn Chirp
10ms
16ms
8
th
Override Method
Custom Code Valet
9
th
Chp Del From TX On
COMPLETING THE INSTALLATION:
NOTE:
This unit has the ability to learn the dome light delay time, up to 60 seconds. If the vehicle has
delay interior lights, and you wish to avoid three chirp, defect zone, indication normally
associated with this type of interior light, we suggest you learn the interior light delay.
To learn the light delay, start with all doors closed:
1) Use the transmitter to Lock / Unlock / Lock / Unlock / Lock / Unlock / Lock, the system. The LED
turns on solid to confirm the system entered the learn mode.
2) Immediately open and close the door of the vehicle to initiate the dome delay. The unit will monitor
the door trigger input Positive, (Purple), and Negative, (Brown) when active. When the dome light
turns off, the unit will add 2 seconds then exit the learn mode.
3) The LED will begin flashing the Armed indication indicating the unit has exited the learn mode and
is armed.
After you have confirmed the operation of the system and tested all of the features:
a. Mount the control module up and behind the dash securing it in place with cable ties or screws.
Be certain that the chosen mounting location will not inhibit any of the controls of the vehicle.
b. Securely harness and tie all wiring up and away from all hot and moving parts that they may come
in contact with under the dash board or in the engine compartment areas.
CAUTION:
Particularly avoid the area around the steering shaft and column, as wires can wrap
around these mechanisms and impair the safe operation of the vehicle.
c. Check the vehicle's wipers, lights, horn, etc.... to insure proper operation.
d. Replace all panels that were removed during installation, and retest the system.
e. Explain all activated features associated with the system installed to the customer.
3.5 Sec.
1 S.L, Dbl.U/L Dbl L, 1 S. UL
Off
Off
Active
Active
Siren
Horn
30ms
40ms
Off
7
5 Chirp/Flash 6 Chirps/Flash
Default
Dbl L, Dbl UL 1S L/350ms UL
1 Sec.
Off
Off
Active
Active
Both
50ms
16ms
Valet
Off
128-8147
7 of 8
Advertisement
