Getting Started; Removing The Belt Clip; Installing The Belt Clip - Oricom PMR1290 Operating Instructions Manual

Pack Contents
Model No. PMR1290
2 UHF RADIOS
1 TWIN CHARGING POD
POWER ADAPTOR
RECHARGEABLE BATTERIES
BELT CLIPS
Installation

Removing the Belt Clip

Pull the Belt Clip latch forward (away from the unit)
While pulling the Belt Clip latch, push up
the Belt Clip as shown in Figure1.

Installing the Belt Clip

Slide the Belt clip into the slot as
shown in Figure2.
A "click" indicates the Belt clip is
locked into position.
Installing the batteries
Caution: Observe the proper battery polarity orientation when installing batteries.
Incorrect positioning can damage both the batteries and the unit.
a. Slide down the Battery Compartment Cover.
b. Install the Rechargeable batteries (supplied) or Alkaline batteries (not supplied)
by following the orientation as shown in Figure 3.
c. Replace the Battery Compartment Cover. See Figure 4.
Model No. PMR1295
2 UHF RADIOS
2 CAR CHARGERS
2 USB CABLES
POWER ADAPTOR WITH Y CABLE
RECHARGEABLE BATTERIES
BELT CLIPS
Figure 1

Getting Started

Belt Clip latch
Figure 2
9