Circuit Board Jumpers - Accurate Technology ProScale 18W User Manual

Circuit Board Jumpers

JP1
JP2
JP3
Front panel programming of the Digital Readout can be enabled or disabled
though the use of this circuit board jumper.
Front panel Programming is enabled when the shorting jumper is installed in
position A. To disable Programming, install jumper on position B.
When programming is disabled, user cannot access the programming
functions via the front panel as described in:
provides a method of configuring the Digital Readout with specific
parameters then preventing unauthorized or accidental configuration
changes.
JP4
JP5
Manual Part # 800-1405-001, Rev A
FACTORY USE ONLY
FACTORY CONFIGURED: DO NOT CHANGE
Programming Lock-out
FACTORY CONFIGURED: DO NOT CHANGE
FACTORY CONFIGURED: DO NOT CHANGE
DRO Circuit Board
PROGRAMMING PARAMETERS
JP3
Default = Position A
.
JP4
JP2
JP5
Page 16 of 20
This