Table of Contents
Advertisement
Key Functions for standard operation
/
ON
OFF KEY
Momentarily press
Momentarily press the
again to turn it back on. The Firmware version is displayed for two seconds
at power-on.
UNITS KEY
Momentarily depressing the
information in inches, fractions or millimeters . With each key press, the
DRO will cycle through decimal inches, fractions (16ths, 32nds, 64ths) and
millimeters.
When the DRO is in 1/16 or 1/32 inch fraction mode, a series of "bars" in the
upper right corner of the LCD, each representing 1/64th of an inch, may
appear.
(ie. When in 1/16 inch mode and three bars are showing, the
measurement displayed is rounded down to the closest 1/16 inch and each
illuminated bar indicates an additional 1/64 of an inch of additional
measurement.) For better resolution, switch to 1/32 or 1/64 mode. For the
best resolution switch to a decimal mode.
When the measurement is greater than 99 63/64 inches, a +100
+200 will illuminate in the upper right portion of the display to indicate this
+200
+200
+200
amount must be added to the displayed reading. ie: If the measurement is
154 5/8 inches, 54 5/8 and +100
measurement is -307 23/64 inches, - 7 23/64, +100
illuminated on the display.
Manual Part # 800-1405-001, Rev A
/
key to turn DRO off then momentarily press it
ON
OFF
Momentarily press
key will display measurement/position
UNITS
+100 will be illuminated on the display. If the
+100
+100
+100
+100 and/or
+100
+100 and +200
+200 will be
+100
+100
+200
+200
Page 12 of 20
Advertisement
Table of Contents
