Installing Your Appliance - Beko CCB 6254 S User Manual

2

Installing your appliance

Assembly and electrical connections must
•
be carried out by specialized personnel.
Wear protective gloves before proceeding
•
with the installation.
Electrical Connection:
The appliance has been manufactured as a
•
class II, therefore no earth cable is necessary.
The plug must be easily accessible after the
installation of the appliance. If the appliance is
equipped with power cord without plug, a suit-
ably dimensioned omnipolar switch with 3 mm
minimum opening between contacts must be
fitted between the appliance and the electricity
supply in compliance with the load and current
regulations.
The connection to the mains is carried out as
•
follows:
BROWN = L line
BLUE = N neutral.
The minimum distance between the support
•
surfaces of the cooking pots on the cooker top
and the lowest part of the cooker hood must be
at least 65 cm. If a connection tube composed
of two parts is used, the upper part must be
placed outside the lower part.
Do not connect the cooker hood exhaust to the
same conductor used to circulate hot air or for
evacuating fumes from other appliances gener-
ated by other than an electrical source. Before
proceeding with the assembly operations, re-
move the anti-grease filter(s) (Fig.7) so that the
unit is easier to handle.
In the case of assembly of the appliance in the
•
suction version prepare the hole for evacuation
of the air.
10 / 15 EN
We recommend the use of an air exhaust tube
•
which has the same diameter as the air exhaust
outlet hole. If a pipe with a smaller diameter
is used, the efficiency of the product may be
reduced and its operation may become noisier.
Installation:
The following instruction should be followed to
carry out the correct installation of the cooker
hood.
1. Mounting of the cooker hood on the lower side
of the cupboard.
1. Choosing the version (extractor, Fig.1A, or filter,
Fig.1B).
Fixing the hood to the lower part of
the wall cabinet:
This type of appliance must be fitted inside a cab-
inet or inside another type of support structure.
The overall measurements of the cooker hood are
given in figure 2. Before proceeding with cooker
hood installation, remove grille D by pressing the
two side buttons A, as shown in figure 3. Fix the
appliance in place using 8 screws (not supplied)
which are suited to the type of cabinet. To install
the cooker hood correctly, first fit the 4 screws
A and then the 4 screws B, in accordance with
the diagram in figure 4. After fixing the cooker
hood to the lower part of the cabinet, place grille
D (Fig.4) back in the correct position. During this
procedure, make sure that grille D is fastened
properly.
Extraction through an outside wall:
The appliance expels the fumes through an
outside wall or a duct. It is necessary to buy a
telescopic pipe in accordance with the standards
in use (inflammable) and connect it to flange H
(Fig.1A).
Cooker Hood / User Manual