Table of Contents
Advertisement
3
Installing your appliance
3.1 Wall drilling and bracket
fixing
3.1.1 Wall mounting
• Draw a vertical line on the at the center of the
wall.
• From bench top (see A), drawing a horizontal
line (see B) above minimum installation height
level.
• Mark a reference point at C, Repeat this step on
the other side.
• Drill ø 8mm holes at center of marking points.
Insert wall plug in the wall.
• Fix the hood body to wall using 2 (ST5 x 25)
screw, tighten the screw firmly.
Note: Adjust the hood body alignment if neces-
sary.
• Place mounting bracket on the wall at desired
height level, aligning bracket center at vertical
line (see D).
Cooker Hood / User Manual
116 116
min. 750 mm
• Mark the center of the bracket holes and drill ø
• Fix the upper chimney cover to both mounting
• Slide the lower chimney cover downwards and
3.2 Aligning the hood body
• Before attaching the hood body, adjust the two
• Hook the hood body onto the support screws
• Adjust screws to level the hood body.
8mm holes. Insert wall plug in the wall. Secure
mounting bracket firmly using 2 (ST5 x 25)
screws.
bracket using 2 (M3 x 12) screws.
ensure that it is well seated on the hood body.
screws located on the hood body mounting
points.
and tighten the support screws fully.
9 / 14 EN
Advertisement
Table of Contents
