Operation Panel In Standby Mode; F1] - Feeding, Cutting Media And Step Adjust; F2] - Cleaning The Heads - MUTOH Spitfire 100 Extreme Operation Instructions Manual

6.2 OPERATION PANEL IN STANDBY MODE

This section describes functions operated on the operational panel when the printer is in the normal status.
Notes
For information of the name and function of each key, refer to "Operation panel".
6.2.1 [F1] – Feeding, Cutting media and Step Adjust
When you want to feed media forward or backward, follow the steps below:
Step 1 : Verify the following regarding the condition of the printer.
I) It is not currently printing
Step 2 : Press the [F1] key of the operation panel.
I) To shift to the Cut&Feed menu.
Step 3 : Press the [F3] key or the [F4] key on the operation panel.
I) The product will perform following operations:
Setup items
Cut & Feed
Notes
If "Take-Up Roll" is set in the media detection setup menu, the product will not operate even if the [F4] key
has been pressed.

6.2.2 [F2] - Cleaning the heads

Step 1 : Press the [F2] key on the operation panel.
Spitfire 100 Extreme series printers – Operation Instructions
Key name
F1
F2
F3
F4
69
Parameters
Cut
Dist.Adj.
Forward
Backward
CHAPTER 6: PRINTER MENU
Description
Cut media
Set step
Feeds media forward.
Feeds media backward.
AP-77200, Rev. 1.1, 05/07/07