Otimer Recording/Playback; Oafter Recording - Technics RS-B655 Operating Instructions Manual

Ti mer Record i ng/Playback
lf an audio timer (not included) is connected to this unit, recording of a radio broadcast, or tape playback, wiil automatically begin at the preset time.
Timer recording or playback is also possible by using a tuner with timer.
Connect the AC power cord of this unit to the power source outlet of the timer. (See the operating instructions of the timer for detailed information.)
2
2
Prepare for recording.
Follow steps 1 through 9 of "Recording" on page 10. After
adjusting the recording level, press the stop buuon.
Set the timer to the deslred recordlng-start time.
(Power "standby 1) /on" switch will be "standby (; "
position.)
\t
Set the timer swltch to
the "rec" posltion.
(At the set time, the pow-
er
"standby (;
lon"
switch will come on and
the broadcast will be re-
corded.)
I After setting the timer
Check to be sure that the power "standby (; lon" switch is set to
the "on" position.
After Recording
Remove the erase-prevention tabs (thus preventing recording).
Use a screwdriver
Tab for side "A" or similar obiect to
break out the tab'
Tab for side "B"
I To re-record on a protected cassette
Cover the slot with adhesive tape.
+
Attach tape.
Rewind the tape to the position from which you want
playback to begin.
(Refer to pages F8.)
Set the timer to the desired playback-start time.
(Power "standby (; /on" switch will be "standby $ "
position.)
3
set the tlmer switch to the
"play" position.
(At the set time, power "stand-
by q) /on" switch will come on
and the playback will begin.)
I After setting the timer
Check to be sure that the power "standby O ion" switch is set to
the "on" position.
When new recordings are made on a recorded tape, all sounds
recorded on that portion of the tape are automatically erased. To
erase a tape without making a new recording, follow the steps
below.
I
I Insert the recorded cassette Into the casaette holder of
tape deck.
r|
Z Set the recording-level control to "0".
\t
Press the Dolby noise-reductlon button corresponding to
the Dolby noise-reductlon indicator that is illuminated.
(This indicator will then switch OFF.)
A
+ Press the record button.
F
C
Press the playback button.
- 1 4 -