Recording After Memory Stop; Automatic-Record-Muting Function; To Make Microphone Recordings - Technics RS-B655 Operating Instructions Manual

2
3
lf a recording is started but the timing is incorrect, the tape can be
rewound to the start point by pressing lhe rewind button, where the
tape will stop automatically and the recording can be started again.
Press the memory-stop button,
(The memory-stop indicator will illuminate.)
Press the counter-leset button.
(The counter will be reset to "0000" and the start point will be
set.)
Follow steps 5 through '11 in "Recording" to begin the
recording.
(Refer to page 10.)
4
To begin the recording again from the beginnlng, press
the rewind (<<) button.
(The tape will be rewound to the set poition where the counter
was reset, and the tape will automatically stop.)
C
Begin the recording once again.
(Follow steps 7, 10-11 in "Recording".)
)To cancel the "memory-stop" operation, press the memory-stop
button once again.
(The memory-stop indicator will be switched OFF.)
Notes:
.The "memory-stop" function can be used while either the tape
counter or the linear counter is displayed, but a change from one
to the other cannot be made during the "memory-stop" mode.
.There may be a slight ditference (maximum +4 seconds)
between the point where the tape counter was reset and the point
where the tape actually stops during rewind.
By simply pressing the automatic-record-muting
button while a
recording is being made, a silent (which is necessary for locating
the beginning of a tune) can be made.
This feature is also convenient for omitting, during recording,
unwanted material such as commercial messages, etc.
You can make your own unique original tapes by using
microphones (not included) to record your instrumental or vocal
performances.
Microphones
(not included)
Connect the microphones to the microphone iack(s).
(A microphone connected to the "L" jack will record sounds
on the tape's left channel, and a microphone connected to the
"R" jack will record sounds on the right channel.)
Begin the recording by tollowlng the sieps described in
the "Recording" sectlon.
Note:
Be sure to disconnect the microphones when recording from a
source (such as a tuner, turntable, etc.) connected to the line input
terminals.
lf they are not disconnected, the source connected to the line input
terminals will not be recorded.
2
421
During the recording,
prbss the automatic-
record:muting button
one time.
To resume recording,
press the playback
button.
FM broadcasts
Record mode
F t n
U o m m e r c f a l 1 t n f 1
announcements.etc. I tt
'
N T
n l n n ,
This unit will make a silent interval (4 seconds long)
between tunes, and then will change to the recording
stand-by mode.
I To make a silent interval of more than 4 seconds on
the tape
Press the automatic-record-mutlng button for the
necessary number of seconds.
The unit will change to the recording stand-by mode when
the button is released.
Automatic-record-muting button
- 1 1 -