Connect To Ethernet And Power On; Connect To The Web Interface - Type A Machines SERIES 1 User Manual

2014 Series 1 User Manual | Version 1.2

3.4 Connect to Ethernet and Power On

Your printer comes with two methods of connection: Ethernet (connecting to a router or base station) and
wireless (Wi-Fi) networking. For initial set up you must use an Ethernet connection.
Attach the power cord and Wi-Fi antenna, then connect the printer via Ethernet cable to your router or Wi-Fi base
station. Ensure that the button on the front panel is not depressed, then turn on the power using the power
switch on the back of the printer. Before powering on your new printer, the Ethernet cable must be connected to
the printer and either a router or Wi-Fi base station in order for the printer to configure its network.
IMPORTANT: To stop all printer activity immediately, depress the lit button on the front panel of your Series 1 printer. To
begin using your printer again, press the button again to return it to its normal state. Then click the Connect button in your
printer's web interface (read more below) to resume using your printer.

3.5 Connect to the Web Interface

If you are a Windows user, you must download Bonjour Print Services to connect your PC to the Series 1. If you
are a Mac user or your PC has iTunes installed, you can skip this step—your PC already has it.
To access the printer's web interface, open a web browser on your computer and enter series1-XXXX.local:5000,
as shown below. Use the last 4 digits of the serial number engraved on the face of your 2014 Series 1 3D Printer
in place of XXXX.
NOTE: It may take several minutes for your printer's web interface to load the first time or after a restart.
typeamachines.com
8