Type A Machines 1 series Setup Manual

TYPE A MACHINES
SERIES 1
SET UP
Congratulations on your new Series 1 3D printer and thank you for choosing Type A Machines.
Follow along with this guide and your Series 1 should be up and printing in under an hour.
Unpack the Series 1
• Once the box top is removed, remove the top
foam piece, the four cardboard pillars, and two
vertical foam pieces on the front of the printer.
Tip: Retain the packaging for upgrade or repair.
• Next, open and pull the plastic moisture bag
down around the printer.
• Remove the two remaining cardboard pillars by
sliding them toward you.
• Remove the cardboard box from under the
platform and set it aside for the moment.
• Next, lift the printer out of the plastic and off of
the base of the box. Lift by the white frame only.
• Remove the foam piece behind the heated
platform cable and connector. To do so, turn the
foam 90 degrees, then slide it out.
Ensure the platform cable is firmly connected.
• Remove the cardboard insert under the sides of
the platform by pulling sideways and rotating.
• Finally, retrieve the Wi-Fi antenna and power
cable from the cardboard box and attach them to
the rear of the printer.
Visit our User Forum
Converse with other Series 1 owners.
forum.typeamachines.com
Warning: The print bed and extruder can be a burn hazard. Always allow to cool before touching.
Need Assistance?
Not recommended for use by those under 12 years of age.
Attach the Spool Holder & Load Filament
• Attach spool holder with included washer &
screw, placing it over the nut on frame. Load
spool, feed filament under and through guide.
• Trim filament end to ensure a clean, pointed tip.
• Press and hold the lever on the extruder's right
side and feed filament in approximately 6.5cm.
Power On the Series 1
• Turn printer on with the power button on right
front panel and confirm it is lit. If not, ensure it is
plugged into a working outlet.
View our Knowledge Base
Find detailed info or submit a support request.
support.typeamachines.com
v3.1.2-524-07-11-16