Table of Contents
Advertisement
TV+
The insTallaTiOn wizard
•
The Installation Wizard will help you configure the main functions of the ARCHOS.
•
If you ever need to relaunch the Installation Wizard, press the reset button. The
ARCHOS will restart and a message will pop up to confirm the relaunch of the
wizard. If you do not respond within 10 seconds, the wizard will be automatically
relaunched.
ATTENTION: if you use the reset button and relaunch the wizard, no data will
be erased but your TV connection settings will be lost, and you will have to set
them up again through the wizard.
NAVIGATING INSIdE THE wIzARd
•
In the different screens of the wizard, use the up/down navigation buttons on the
remote control to highlight a parameter.
•
Use the left/right buttons to select a different setting for a parameter.
•
When you have finished adjusting your settings, use the navigation buttons to high-
Next
light "
" and press OK
•
If you want to go back to a previous screen, select "
CoNfIGURING THE wIfI/ETHERNET CoNNECTIoN
•
At the end of the Installation Wizard, in the "
configure your WiFi/Ethernet connection.
WiFi
•
Choose "
", "
"
None
", based on the way you want to connect to the Internet (or local network).
If you do not have access to the Internet, select "
•
See "Network" Settings .
Turning The arChOs On/Off
•
Press the Power button
it into standby mode.
•
The green LED indicator, on the front of the device, lights up when the device is
on. The red LED lights up when the device is in standby mode.
MANUAL
V1.0
on the remote control to move on to the next screen.
Ethernet Cable
" (standard Ethernet cable not supplied) or
on the remote control to turn on your ARCHOS or put
Previous
".
Network
" screen, you are invited to
None
".
STARTING UP > P. 9
Hide quick links:
Advertisement
Table of Contents
