Archos TV+ User Manual page 65

TV+
4. Select the " Test power Off code
ARCHOS device will then try to turn your tuner off. After a few seconds, your
ARCHOS will ask you if the device responded correctly:

If your tuner turned off, select "

If your tuner did not turn off, select "
ing the tuner off again, using a different code. Repeat this operation until the
ARCHOS manages to turn the tuner off.
If none of the codes work, check that the ARCHOS is positioned in a way that
allows the infrared signal to reach your tuner's receiver. Note: In some rare
cases the ON/OFF functionality may not work.
 Test: changing channels on your tuner
nd
Yes
After you select "
you to correctly set the parameters so that the ARCHOS can change channels on your
tuner (for a scheduled recording).
Channel
1. For the "
rized on your tuner.
2. Select the " Test channel select
ARCHOS device will then attempt to switch your tuner to the selected channel.
After a few seconds, your ARCHOS will ask you if the device responded correctly:

If this worked, select "

If this did not work, select "
switch your tuner to the selected channel, using a different option*. Repeat this
operation until it successfully changes the channel on your TV receiver.
*Here is a description of the different parameters automatically set by the ARCHOS:
-
"Key Delay": delay between the emission of each digit of a channel ("
-
"Key: Enter": Set to "
after you enter the channel number. Example: If you normally press 1, 3, "
this parameter is set to "
MANUAL
V1.0
" button. Make sure that your tuner is on. Your
Yes
" at the end of the 1
" parameter, select the highest channel that is currently memo-
" button. Make sure that your tuner is on. Your
Yes
".
No, try next option
On
" if normally, you have to press an "
On
".
", and move on to the next section.
No, try next code
test, the following screen appears. It allows
st
". Your device will try again to
OK
" button on your turner's remote control
THE TV PRoGRAM GUIdE > P. 65
". Your device will try turn-
Short Normal Long
", " ", "
OK
" to access channel 13, then
").