Seat Belt - Mercedes-Benz M-Class Operator's Manual

Care
324
plastic trim. This maintains the high-quality
look of the surfaces.
Wipe the plastic trim with a damp, lint-free
X
cloth, e.g. a microfiber cloth.
Heavy soiling: use car care and cleaning
X
products recommended and approved by
Mercedes-Benz.
The surface may change color temporarily.
Wait until the surface is dry again.
Cleaning the steering wheel and gear or
selector lever
Thoroughly wipe with a damp cloth or use
X
leather care agents that have been
recommended and approved by Mercedes-
Benz.
Cleaning genuine wood and trim
elements
Wipe the wooden trim and trim pieces with
X
a damp, lint-free cloth, e.g. a microfiber
cloth.
Heavy soiling: use car care and cleaning
X
products recommended and approved by
Mercedes-Benz.
!
Do not use solvent-based cleaning agents
such as tar remover, wheel cleaners,
polishes or waxes. There is otherwise a risk
of damaging the surface.
!
Do not use chrome polish on trim pieces.
The trim pieces have a chrome look but are
mostly made of anodized aluminum and
can lose their shine if chrome polish is
used. Use a damp, lint-free cloth instead
when cleaning the trim pieces.
If the chrome-plated trim pieces are very
dirty, you can use a chrome polish. If you
are unsure as to whether the trim pieces
are chrome-plated or not, consult an
authorized Mercedes-Benz Center.
Cleaning the seat covers
!
Do not use microfiber cloths to clean
genuine leather, artificial leather or
Alcantara® covers. If used often, these can
damage the cover.
!
Observe the following when cleaning:
clean genuine leather covers carefully
R
with a damp cloth and then wipe the
covers down with a dry cloth. Make sure
that the leather does not become
soaked. It may otherwise become rough
and cracked. Only use leather care
agents that have been tested and
approved by Mercedes-Benz. You can
obtain these from a qualified specialist
workshop, e.g. a Mercedes-Benz Service
center.
clean artificial leather covers with a cloth
R
moistened with a solution containing 1%
detergent (e.g. dish washing liquid).
clean cloth covers with a microfiber cloth
R
moistened with a solution containing 1%
detergent (e.g. dish washing liquid). Rub
carefully and always wipe entire seat
sections to avoid leaving visible lines.
Leave the seat to dry afterwards.
Cleaning results depend on the type of
dirt and how long it has been there.
clean Alcantara® covers with a damp
R
cloth. Make sure you wipe entire seat
sections to avoid leaving visible lines.
i
Note that regular care is essential to
ensure that the appearance and comfort of
the covers is retained over time.
Cleaning the seat belts
Use clean, lukewarm water and soap
X
solution.
!
Do not clean the seat belts using chemical
cleaning agents. Do not dry the seat belts
by warming them above 176 ‡ (80 †) or
placing them in direct sunlight.
I n f o r ma t i o n P r o v i d e d b y :