Windshield Washer System - Mercedes-Benz M-Class Operator's Manual

Further information on engine oil
( page 388).
Y
Checking and adding other service
products
Checking the coolant level
Only check the coolant level when the vehicle
is on a level surface and the engine has cooled
down.
Turn the SmartKey to position
X
2 ( page 139) in the ignition lock.
Y
On vehicles with KEYLESS-GO, press the
Start/Stop button twice (
Check the coolant temperature gauge in
X
the multifunction display.
The coolant temperature must be below
158 ‡ (70 †).
G WARNING
In order to avoid any potentially serious burns:
use extreme caution when opening the
R
hood if there are any signs of steam or
coolant leaking from the cooling system, or
if the coolant temperature display indicates
that the coolant is overheated.
do not remove the pressure cap on the
R
coolant reservoir if the coolant temperature
is above 158 ‡ (70 †). Allow the engine to
cool down before removing the cap. The
coolant reservoir contains hot fluid and is
under pressure.
using a rag, slowly turn the cap
R
1
approximately /
2
pressure. If opened immediately, scalding
hot fluid and steam will be blown out under
pressure.
do not spill antifreeze on hot engine parts.
R
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts.
page 139).
Y
turn to relieve excess
I n f o r ma t i o n P r o v i d e d b y :
Engine compartment
Slowly turn cap : half a turn counter-
X
clockwise and allow excess pressure to
escape.
Turn cap : further counter-clockwise and
X
remove it.
If the coolant is at the level of marker bar
= in the filler neck when cold, there is
enough coolant in coolant expansion
tank ;.
If the coolant is approximately 0.6 in
(1.5 cm) above marker bar = in the filler
neck when warm, there is enough coolant
in coolant expansion tank ;.
If necessary, add coolant that has been
X
tested and approved by Mercedes-Benz.
Replace cap : and turn it clockwise as far
X
as it will go.
For further information on coolant, see
( page 389).
Y
Windshield washer system and
headlamp cleaning system
The washer fluid reservoir is used for both the
windshield washer system and the headlamp
cleaning system.
i
Vehicle components and their service
products must match. You should,
therefore, only use products that have been
tested and approved by Mercedes-Benz.
Information on tested and approved
products can be obtained at any authorized
Mercedes-Benz Center or on the Internet at
http://www.mbusa.com (USA only).
315
Z