Activation Conditions - Mercedes-Benz M-Class Operator's Manual

Driving systems
172
This device has been approved by the FCC
as a "Vehicular Radar System". The radar
sensor is intended for use in an automotive
radar system only. Removal, tampering, or
altering of the device will void any
warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
i
Canada only: This device complies with
RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause interference,
and
2. this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Removal, tampering, or altering of the
device will void any warranties, and is not
permitted. Do not tamper with, alter, or use
in any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
Cruise control lever
To activate or increase speed
:
To activate or reduce speed
;
To deactivate DISTRONIC PLUS
=
To activate at the current speed/last
?
stored speed
To set the specified minimum distance
A
Activating DISTRONIC PLUS

Activation conditions

In order to activate DISTRONIC PLUS, the
following conditions must be fulfilled:
the engine must be started. It may take up
R
to two minutes after pulling away before
DISTRONIC PLUS is operational.
the electric parking brake must be
R
released.
®
ESP must be active, but not intervening.
R
the transmission must be in position D.
R
the driver's door must be closed when you
R
shift from P to D or your seat belt must be
fastened.
the front-passenger door and rear doors
R
must be closed.
DSR must be deactivated.
R
the vehicle must not skid.
R
Activating while driving
When driving at speeds below 20 mph
(30 km/h), you can only activate DISTRONIC
PLUS if the vehicle in front has been detected
and is shown in the multifunction display. If
the vehicle in front is no longer detected and
displayed, DISTRONIC PLUS switches off and
a tone sounds.
Briefly pull the cruise control lever towards
X
you ?, or briefly press up : or down ;.
DISTRONIC PLUS is selected.
Keep the cruise control lever pressed
X
up : or down ; until the desired speed
is set.
Remove your foot from the accelerator
X
pedal.
Your vehicle adapts its speed to that of the
vehicle in front, but only up to the desired
stored speed.
i
If you do not fully release the accelerator
pedal, the DISTRONIC PLUS Passive
message appears in the multifunction
display. The set distance to a slower-
moving vehicle in front will then not be
maintained. You will be driving at the speed
I n f o r ma t i o n P r o v i d e d b y :