Table of Contents
Advertisement
Navigate to ADDR INFORMATION and press OPEN to enter.
Change ADDR TYPE to SOFT by moving left or right using your PTZ
controller. Next, navigate to ADDR-SOFT and set your desired address
by moving right to increase, or left to decrease.
Once the desired address has been set, navigate to SAVE and press
OPEN to save the address settings. Finally, navigate to EXIT and press
OPEN on your PTZ controller to exit the OSD MENU.
Basic Operation
The table below is a quick guide to the camera's basic operations using
a PTZ controller.
Function
Pan/Tilt
Zoom Out
Zoom In
Focus Near
Focus Far
Note: the camera will attempt auto-focus after being panned, tilted, or zoomed.
Enter OSD Menu
Confirm Menu Selection
Set Left Point
Set Right Point
Begin Left/Right Scan
End Left/Right Scan
5
Operation
Move joystick or press arrows left, right, up, or down.
Press WIDE or rotate the joystick counter-clockwise for the
desired image.
Press TELE or rotate the joystick clockwise for the desired
Press NEAR until there is a clear image.
Press FAR until there is a clear image.
CALL Preset 95
WRITE Preset 92
WRITE Preset 93
CALL Preset 99
Move joystick or press arrows left, right, up, or down.
image.
Press OPEN
Advertisement
Table of Contents
