Related Manuals for Security Tronix HD-COAXINATOR ST-HD-IRPTZ-2MP
Summary of Contents for Security Tronix HD-COAXINATOR ST-HD-IRPTZ-2MP
- Page 1 Professional Pan Tilt Zoom Camera ST-HD-IRPTZ-2MP INSTALLATION MANUAL www.nacebrands.com www.securitytronix.com...
-
Page 2: Specifications
Description: The ST-HD-IRPTZ-2MP is a professional-grade intelligent dome color camera with IR and Pan/Tilt/Zoom (PTZ) capabilities, and 1080p resolution. The camera is designed to function with HD-COAXINATOR™ recorders to utilize Control Over Coax (COC) without the need for an additional RS485 connection. Specifications: Image Sensor 1/2.8”... -
Page 3: Setup And Installation
Unpacking Package Contents: (1) ST-HD-IRPTZ-2MP High-Speed IR Color Camera (1) Wall Mounting Bracket (1) Safety Hook (1) 24V AC Power Supply (1) Installation Manual Ensure that all accessories and documentation are removed from the container before discarding packing material. Inspect the front, sides, and rear of the equipment for shipping damage. - Page 4 Do not install the camera near a magnetic field or a high- power motor. Do not mount the camera near a radiator or heater. The installation site and material must fully support the weight of the product. ...
- Page 5 Making Connections 1. Connect the AC power supply cable to the camera’s power leads. 2. Connect the camera to the CVR with a 75Ω coaxial video cable. 3. (Optional) Connect unshielded twisted pair (UTP) control cable between the camera’s labeled RS485 leads and the PTZ controller.
-
Page 6: Basic Operation
Navigate to ADDR INFORMATION and press OPEN to enter. Change ADDR TYPE to SOFT by moving left or right using your PTZ controller. Next, navigate to ADDR-SOFT and set your desired address by moving right to increase, or left to decrease. Once the desired address has been set, navigate to SAVE and press OPEN to save the address settings. - Page 7 Setting a Tour After PRESET locations have been set, enter the OSD MENU, then use the joystick or up/down arrows to navigate to FUNCTION SETTING and press OPEN to enter. Next, navigate to TOUR and press OPEN. Using the controller’s joystick or arrow buttons, move left or right at TOUR NO to select the desired tour to edit, then navigate to SETTING and press OPEN.
-
Page 8: Troubleshooting
PRESET indicates which preset number will be called for the tour position. DWELL indicates the amount of time the camera will spend at the tour position. SPEED indicates the speed that the camera will move to the next tour position. -
Page 9: For Further Assistance
continuously changing Check that the coaxial video cable between the camera Colors. and CVR is not too close to fluorescent lights; increase distance as needed. (2) Reduce the number of fluorescent lights near the camera. Power and video are on, (1) Check to ensure that the controller is set to the baud but the controller does rate, address, and protocol of the camera. - Page 12 Version 1.0 (3/25/15) © 2015 North American Cable Equipment.