Removing And Reinstalling The Software - Lexmark 2500 Series Getting Started Manual

Black and Color
cartridge
replacement required

Removing and reinstalling the software

If the printer is not functioning properly, or if a communications error message appears when you try to use the
printer, you may need to remove and reinstall the printer software.
1
Click Start Programs or All Programs
2
Select Uninstall.
3
Follow the instructions on the computer screen to remove the printer software.
4
Restart the computer before reinstalling the printer software.
5
Click Cancel on all New Hardware Found screens.
6
Insert the CD, and then follow the instructions on the computer screen to reinstall the software.
Note: If the install screen does not appear automatically after you restart your computer, click Start
type D:\setup, where D is the letter of your CD-ROM drive.
New print cartridges need to be installed.
The print job has been canceled.
Note: A variable amount of ink remains in the black (or photo) and color print
cartridges.
1
Replace the print cartridges with new cartridges. For more information, see
"Removing a used print cartridge" on page 35 and "Installing print cartridges"
on page 35.
2
Print again.
To order supplies, click Order Ink on your computer screen. You can also see
"Ordering paper and other supplies" on page 40 in this guide.
Lexmark 2500 Series.
Troubleshooting
55
Run, and then