Sony UP-D711MD Instructions For Use Manual

Sony UP-D711MD Instructions For Use Manual

Digital graphic printer
Hide thumbs Also See for UP-D711MD:

Advertisement

4-417-500-12 (1)
Digital Graphic
Printer
Instructions for Use
UP-D711MD
© 2012 Sony Corporation

Advertisement

Table of Contents
loading

Summary of Contents for Sony UP-D711MD

  • Page 1 4-417-500-12 (1) Digital Graphic Printer Instructions for Use UP-D711MD © 2012 Sony Corporation...
  • Page 2: Owner's Record

    Refer to these numbers whenever you call upon your 1. All the equipments connected to this unit shall be Sony dealer regarding this product. certified according to Standard IEC60601-1, IEC60950-1, IEC60065 or other IEC/ISO Standards Model No. ______________ applicable to the equipments.
  • Page 3 D711MD. Guidance and manufacturer’s declaration-electromagnetic emissions The UP-D711MD is intended for use in the electromagnetic environment specified below. The customer or the user of the UP-D711MD should assure that it is used in such an environment. Emission test Compliance Electromagnetic environment-guidance...
  • Page 4 Guidance and manufacturer’s declaration-electromagnetic immunity The UP-D711MD is intended for use in the electromagnetic environment specified below. The customer or the user of the UP-D711MD should assure that it is used in such as environment. Immunity test IEC 60601 test level...
  • Page 5 Guidance and manufacturer’s declaration-electromagnetic immunity The UP-D711MD is intended for use in the electromagnetic environment specified below. The customer or the user of the UP-D711MD should assure that it is used in such as environment. Immunity test IEC 60601 test level...
  • Page 6 Recommended separation distances between portable and mobile RF communications equipment and the UP-D711MD The UP-D711MD is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of the UP-D711MD can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment (Transmitters) and the UP-D711MD as recommended below, according to the maximum output power of the communications equipment.
  • Page 7: Table Of Contents

    Table of Contents Owner’s Record ............. 2 WARNING ............. 2 Getting Started Overview ..............8 Location and Function of Parts and Controls ..8 Front Panel ............8 Rear Panel ............9 Checking the accessories ........9 Connections ............9 Connecting to the USB Connector .....
  • Page 8: Getting Started

    Getting Started Location and Function of Parts and Controls For more details, see the referenced page numbers Overview enclosed in parentheses ( ). Quiet, High Quality, Fast Printing Front Panel • Employs a thin thermal head with a built-in high speed drive IC, capable of high resolution images of 11.8 dots/mm.
  • Page 9: Rear Panel

    Use a Hosiden–manufactured connector to connect. Part no: TCP8927-53 Connecting to the USB Connector Wire rod: For voltages above 60V at max. The wire rod’s rating must be more than 7A. UP-D711MD DC12~24V (6-3A) (USB) connector Insert the connector with the (USB) mark facing up.
  • Page 10: Connecting The Dc Cable

    Connecting the DC Cable Paper Use only Sony UPP-84S/84HG paper designed for use with this unit. High print quality cannot be guaranteed if any other paper is used with this unit, and such paper could damage the unit. Paper You Can Use Paper characteristics are as follows.
  • Page 11: Loading Paper In The Unit

    • Do not store printouts near volatile liquids or allow the Loading Paper in the prints to contact any organic volatile liquid, cellophane tape, or any compound of vinyl chloride. Unit • To prevent fading, do not stack printouts on or under a diazo copy sheet.
  • Page 12: Loading Paper

    Loading Paper Load the paper with the printing side (heat sensitive side) up. Printing is not possible if the paper is reversed. Press the 1 switch to turn the unit on. The 1 lamp lights green. The PAPER lamp lights orange if no paper is loaded.
  • Page 13: Operation

    Cutting Paper Operation Hold the printer firmly, then pull the paper diagonally upwards and cut it as shown in the figure. Printing Before Starting a Print Job Always check the following points: • Unit connected correctly? (page 9) • Printer driver installed? (page 10) •...
  • Page 14: Others

    • Do not place the unit in a location subject to strong Others light, such as a halogen lamp. • Do not place the unit in an excessively hot or humid place. Avoid locations near radiators or air ducts, or places subject to direct sunlight or excessive dust, humidity, mechanical shock or vibration.
  • Page 15: Maintenance

    Insert the cleaning sheet, with the black surface Maintenance facing down, into the groove of the paper tray. Insert the cleaning sheet into the Cleaning the Cabinet grooves of the paper tray. Use a wrung out damp cloth, or a damp cloth soaked in water and a mild detergent, to clean the cabinet surface.
  • Page 16: Cleaning The Platen Roller

    Press and hold down the FEED button so that the Cleaning the Platen Roller platen roller turns automatically. Release the FEED When the surface of the platen roller gets dirty, paper button when the surface of the platen roller to be will not be ejected smoothly after printing, resulting in cleaned appears.
  • Page 17: Specifications

    Printing speed SOFTWARE. About 5 sec./image (896 × 1196 dots) (High speed print mode) • SONY WILL NOT BE LIABLE FOR DAMAGES About 8 sec./image (896 × 1196 dots) OF ANY KIND INCLUDING, BUT NOT (Normal speed print mode) LIMITED TO, COMPENSATION OR...
  • Page 18: Troubleshooting

    USB cable the door, remove the printout or and the DC cable, then consult the paper roll, and then gently your Sony dealer. pull the jammed paper out of the unit. • Condensation collected in unit? tIf the unit has just been brought...
  • Page 19: Index

    Index Connections 9 Getting Started 8 Lamp 18 Location and function of parts and controls front panel 8 rear panel 9 Maintenance cleaning the cabinet 15 cleaning the platen roller 16 cleaning the thermal head 15 Overview 8 Paper feeding 13 loading 12 notes on storing and handling 10 paper you can use 10...
  • Page 20 Sony Corporation...

Table of Contents