Spektrum AR9020 User Manual page 8

EN
IMPORTANT: Do not use amplified Y-harnesses and servo extensions with
Spektrum equipment. Only use standard non-amplified Y-harnesses and servo
extensions. When converting existing models to Spektrum technology, replace all
amplified Y-harnesses and/or servo extensions with conventional non-amplified
versions.
Binding
You must bind the receiver to the transmitter before the receiver will operate.
Binding teaches the receiver the specific code of the transmitter, so it will only
connect to that transmitter.
1. To bind an AR9020 to a DSM2 or DSMX transmitter, insert the bind plug in the
BIND/DATA port on the receiver.
To bind an aircraft with an electronic speed controller that powers the receiver
through the throttle channel (ESC/BEC), insert the bind plug into the BIND/DATA
port in the receiver and the throttle lead into the throttle (THRO) port. Proceed to
Step #2.
2. Power on the receiver. The LED on the internal receiver board and all of the
attached receivers should be flashing, indicating the receiver is in bind mode.
3. Move the sticks and switches on the transmitter to the desired failsafe positions
(low throttle and neutral control positions).
8