Connecting To Web-Based Interface - D-Link DIR-620 User Manual

DIR-620 Multifunction Wireless Router Supporting WiMAX, 3G GSM/CDMA
with Built-in Switch
User Manual
If you perform initial configuration of the router via Wi-Fi connection, note that
!
immediately after changing the wireless default settings you will need to reconfigure the
wireless connection using the newly specified settings.

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.).
1. Start a web browser (see the Before You Begin section, page 12).
2. In the address bar of the web browser, enter the IP address of the router (by default, the
following IP address is specified: 192.168.0.1). Press the Enter key.
Figure 7. Connecting to the web-based interface of the DIR-620 device.
3. On the opened page, enter the username (login) and password for the administrator account
(by default, the following username and password are specified: admin, admin). Then
click the Enter button.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
Right after the first access to the web-based interface you are forwarded to the page for changing
the administrator password specified by default.
Figure 8. The login page.
Page 18 of 107
Installation and Connection