Pc With Wi-Fi Adapter; Configuring Wi-Fi Adapter - D-Link DIR-620 User Manual

DIR-620 Multifunction Wireless Router Supporting WiMAX, 3G GSM/CDMA
with Built-in Switch
User Manual

PC with Wi-Fi Adapter

1. To connect via a WiMAX, 3G GSM or CDMA network: connect your USB modem to the
USB port 5 located on the front panel of the router.
!
If you need to connect or change a USB modem to another one when the router is powered
on, power off the device, connect the modem to the USB port, and power on the router.
2. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
3. Turn on your PC and wait until your operating system is completely loaded.
4. Turn on your Wi-Fi adapter. As a rule, modern notebooks with built-in wireless NICs are
equipped with a button or switch that turns on/off the wireless adapter (refer to your PC
documents). If your PC is equipped with a pluggable wireless NIC, install the software
provided with your Wi-Fi adapter.

Configuring Wi-Fi Adapter

1. Click the Start button and proceed to the Control Panel > Network and Internet
Connections > Network Connections window.
2. Select the icon of the wireless connection and make sure that your Wi-Fi adapter is on.
3. Search for available wireless networks.
4. In the opened Wireless Network Connection window, select the needed wireless
network (DIR-620) and click the Connect button.
After that the Wireless Network Connection Status window appears.
5 It is recommended to a USB extension cable to connect a USB modem to the router.
Figure 6. The Network Connections window.
Page 17 of 107
Installation and Connection