Panasonic WV-SPW631LT Installation Manual page 23

Waterproof treatment for the cable joint sections
Adequate waterproof treatment is required for the cables when installing the camera with cables
exposed or installing it under the eaves. The camera body is waterproof, but the cable ends are not
waterproof.
Be sure to use the supplied waterproof tape (accessory) at the points where the cables are connect-
ed to apply waterproof treatment in the following procedure. Failure to observe this or use of a tape
other than the provided waterproof tape (such as a vinyl tape) may cause water leakage resulting in
malfunction.
LAN cable
Wind the tape in a half-
overlapping manner.
Alarm input/output cable, power cable, microphone/ line input cable, audio output cable
Wind the tape in a
half-overlapping manner.
IMPORTANT:
How to wind the supplied waterproof tape
• Also waterproof the 2P power cable, 4P alarm cable, and
external connections in the same way.
• Stretch the tape by approx. twice (see the illustration) and
wind it around the cable. Insufficient tape stretch causes
insufficient waterproofing.
• To prevent the LAN cable hook from coming loose easily,
fit the Ⓙ LAN cable cover onto the pigtail cable as illustrat-
ed, and then slide it in the direction indicated by the arrow.
The connector of the LAN cable used with this camera
must meet the following restrictions.
Height when inserted (From bottom to hook.): Max. 16 mm
{5/8 inches}
Connector width: Max. 14 mm {9/16 inches}
• T o install this product outdoors, be sure to waterproof the
cables. Waterproof grade (IEC IP66 or equivalent) is
applied to this product only when it is installed correctly as
described in these operating instructions and appropriate
waterproof treatment is applied. The internal parts of base
brackets are not waterproofed.
Stretch the tape to
about twice.
Ⓙ LAN cable cover
The hook engages with the
connector terminal
2x
23