Panasonic WV-SPW631LT Installation Manual page 21

Hide thumbs Also See for WV-SPW631LT:
Table of Contents

Advertisement

2
C onnect an external amplifier-embedded speaker to the audio output cable.
Connect a stereo mini plug (ø3.5 mm) (Audio output is monaural.).
• Output impedance: Approx. 600 Ω (unbalanced)
• Recommended cable length: Less than 10 m {32.8 ft}
• Output level: –20 dBV
* Use an external powered speaker.
IMPORTANT:
• C onnect/disconnect the audio cables and turn on the power of the camera after turning off the
power of the audio output devices. Otherwise, loud noise may be heard from the speaker.
• M ake sure that the stereo mini plug is connected to this cable. When a monaural mini plug is
connected, audio may not be heard.
When connecting a monaural speaker with amplifier, use a locally procured conversion cable
(mono-stereo).
3
Connect the alarm input/output cable.
4P alarm cable
<Ratings>
• ALARM IN1(DAY/NIGHT IN), ALARM IN2, ALARM IN3
Input specification:
OFF:
ON:
• ALARM OUT, AUX OUT
Output specification: Open collector output (maximum applied voltage: 20 V DC)
Open:
Close:
* The default of EXT I/O terminals is "Off".
IMPORTANT:
• Be sure to use the 4P alarm cable provided with this product.
• Off, input, and output of the external I/O terminal 2 and 3 can be switched by configuring the
setting. Refer to the Operating Instructions on the provided CD-ROM for further information
about the EXT I/O terminal 2 and 3 (ALARM IN2, 3) settings ("Off", "Alarm input", "Alarm out-
put" or "AUX output").
• When using the EXT I/O terminals as the output terminals, ensure they do not cause signal col-
lision with external signals.
• Install external devices so that they do not exceed the ratings above.
GND (black)
ALARM IN3, AUX OUT (gray) (Terminal 3)
ALARM IN2, ALARM OUT (red) (Terminal 2)
ALARM IN1, DAY/NIGHT IN (green) (Terminal 1)
No-voltage make contact input (4 V - 5 V DC, internally pulled up)
Open or 4 V - 5 V DC
Make contact with GND (required drive current: 1 mA or more)
4 V - 5 V DC by internal pull-up
Output voltage 1 V DC or less (maximum drive current: 50 mA)
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wv-spw631lWv-spw611lWv-spw611

Table of Contents