Parts List & Tools Required; Parts Supplied; Tools You Will Need Ideally - Origin live THE RESOLUTION CLASSIC Instructions For Use Manual

Parts list & tools required

Parts supplied

Ultra plinth, 4 small rubber feet
Lid, (usually fitted with 2 off Lid hinges bottom & 2 top, 4 off M4 x 10mm bolts, 4 off M4 nuts.
Bag – Belt, Oil, 1 off arm cable clip (large), 1 off motor cable clip (small), 2 off no 6 x •" screws, arm packing ring
(unless sliding vta is fitted). 2 off cork feet
Bag - 3 springs / 3 long M5 x 80 bolts / 3 spring seats / 3 rubber washers / 6 off M5 washers / 9 off M5 serrated
washers / 6 off M5 nuts / 4 off large washers + 2 on transit bolts
Platter
Sub-chassis ( MDF damper arm & spring plates, glued washers), Main bearing house on sub-chassis, Sub-platter
Motor with fitted pulley – (attached)
Switch box
Power supply 230 volt or 110 volt (delete one)
Upgrade Transformer (optional)
Sliding VTA adjuster, Aluminium sleeve, allen set screw (optional)
Threaded VTA adjuster and packing washer (optional)
Arm (optional)
Paperwork
Turntable instructions
Strobe card

Tools you will need ideally

Ruler or measuring tape
Marker pen.
Small hacksaw or powerful snips
Cross head screwdriver
3mm or 3.5mm drill
Pliers or molegrips
Hammer
Soldering iron (not essential)
Spirit level
5