Table of Contents
Advertisement
Quick Links
Aurora & Calypso MK4
IMPORTANT NOTES
Never remove the silver strip on underside of
platter.
Motor Pod blue light under platter must come
on when platter is driven. If not reposition
motor pod or raise deck till it does.
For Multi Layer platters - slacken screws as
per instructions.
Never stretch the belt except to place it over
the pulley. If you test stretch the belt you can
damage it resulting in future breakage
MOTOR POD
Turntable Manual
PLATTER
Arm shown is not included
It cannot be overstated that
it is VERY important to read
these instructions or the
speed control may not
function accurately.
PLINTH
SUB-CHASSIS
Advertisement
Table of Contents
Related Manuals for Origin live Aurora MK4
Summary of Contents for Origin live Aurora MK4
- Page 1 Aurora & Calypso MK4 Turntable Manual IMPORTANT NOTES Never remove the silver strip on underside of platter. It cannot be overstated that Motor Pod blue light under platter must come it is VERY important to read on when platter is driven. If not reposition motor pod or raise deck till it does.
-
Page 2: Safety Warnings
8mm A/F spanner – (12 inch arms only) not exact representation. Platter Origin Live turntables are simple to set up. The Upgrade platter mat instructions appear lengthy because they give proper explanation of factors that are different to conventional 1 Belt + Spindle for platter + Strobe card ... - Page 3 Do not use the belt is fitted, then remove the platter and clean taper anything other than Origin Live oil for performance surfaces. Refit it till it sits true. reasons.
- Page 4 Set the plinth height by rotating the 3 adjustable feet. It helps to lift the deck slightly for access to each foot in turn.Set the Platter Height To set the plinth height correctly, place the motor pod just beside the platter as shown above. Set plinth height using the adjustable feet, to give the platter mm to 7mm...
- Page 5 Note that only the LED next to the knob lights up at this People sometimes comment that the plastic pulley looks stage and will remain on to show item is connected to cheap - However it's made from a special plastic which the mains.
-
Page 6: Fit The Tonearm
You can purchase bayonet fitting fluorescent or halogen bulbs to fit normal lamps. Try to shut out daylight when If you have an older Origin Live or Rega tone-arm which carrying out speed reading. Also be aware that energy has a threaded base but no vta adjustment, you can fit a saving lighting with switch mode high frequency power threaded VTA adjuster. -
Page 7: Maintaining Your Deck
2 to 4 years. Every 3 years Only use Origin Live oil. Oil should be replaced every 3 Final setup of tonearm to 4 years so you will need to clean out the old oil with a... - Page 8 REPACKING METHOD - Please read carefully and pack exactly as instructions show. Wrap motor pod in polythene bag then tape ( or BELT & STROBE CARD PLACED IN MOTOR rubber band) round the cardboard tube which has POD PACKING a slit in it’s side - the tube sits on top of the base The belt needs to be rolled into a spiral and plate, not round it.
Need help?
Do you have a question about the Aurora MK4 and is the answer not in the manual?
Questions and answers