JOHNSON SYSTEMS JS-ICON 2410 User Manual page 28

43. FW-LOAD
DISABLED
ENABLED
MEMCHECK
CRC-TEST
>>>>>>>>
VER X.X
UPDATE??
SURE ???
UPDATING
WILL
AUTO
RESTART
PLEASE
WAIT....
NO MEM!
WRONG
MEM TYPE
WRONG
PRODUCT
CRC ERR!
44. RESTORE
DISABLED
ENABLED
MEMCHECK
OKAY....
PROCEED?
SURE ???
CRC-TEST
WAIT
VERIFY
DONE!!
WILL
AUTO
28
Load new firmware into the MADD-24 via the EEPROM memory module.
If a firmware update is required, Johnson Systems Inc. may supply an EEPROM
memory module with the latest firmware version. The firmware EEPROM memory
module can be inserted into PORT1 on the MADD-24 board and the firmware can be
loaded into the microcontroller.
Press EXECUTE to enter the menu.
This menu is disabled for inadvertent use. Proceed to enable.
Press and hold MENU ( ) and MENU (
Automatically checks the EEPROM memory module for firmware type.
Automatically does a CRC test on the firmware code in the EEPROM.
The CRC test in progress.
Displays the firmware version on the EEPROM memory module.
Press EXECUTE to proceed.
Press EXECUTE to proceed.
Firmware update in progress.
Firmware update in progress.
Firmware update in progress.
Firmware update in progress.
Firmware update in progress.
When firmware update is complete the RUN LED flashes and system restarts.
Displayed if an EEPROM memory module is not detected.
Displayed if the wrong type (parameter) of EEPROM memory module detected.
Displayed if the wrong type (parameter) of EEPROM memory module detected.
Displayed if the wrong product type of EEPROM memory module detected.
Displayed if the wrong product type of EEPROM memory module detected.
Displayed if the CRC test fails and the EEPROM memory module is defective.
WARNING: Do not reset or turn the power off while the firmware is being updated.
Doing so will cause unrecoverable loss of firmware data that is being loaded into the
MADD-24 microcontroller.
Restore parameters saved in the EEPROM memory module.
All of the configuration setting parameters can be restored from the EEPROM
memory module if they have been inadvertently changed or corrupted. This feature
can also be used to load configuration setting parameters into a different or new
control module. This reduces the configuration time for multi-system applications that
require similar settings or when a replacement control module is required.
Press EXECUTE to enter the menu.
This menu is disabled for inadvertent use. Proceed to enable.
Press and hold MENU ( ) and MENU (
Automatically checks the EEPROM memory module for parameter type.
The EEPROM memory module has been verified for parameter type.
Press EXECUTE to proceed.
Press EXECUTE to proceed.
Automatically does a CRC test on the parameter code in the EEPROM.
CRC test in progress.
CRC test in progress.
CRC test is done and the parameter restore automatically begins.
Parameter restore in progress.
Parameter restore in progress.
www.johnsonsystems.com
) at the same time for 4-5 seconds.
) at the same time for 4-5 seconds.