Download  Print this page

Advertisement

Changing the Lamp

Replace the lamp when the message "Lamp is approaching the
end of its useful life. Replacement suggested!
www.dell.com/lamps" appears on the screen. If this problem persists
after replacing the lamp, contact Dell.
CAUTION:
The lamp becomes very hot when in use. Do not attempt to replace
the lamp until the projector has been allowed to cool down for at least
30 minutes.
CAUTION:
Do not touch the bulb or the lamp glass at any time. The bulb may
explode due to improper handling, including the touching of the bulb or the
lamp glass.
Turn off the projector and disconnect the power cord.
1
Let the projector cool for at least 30 minutes.
2
Loosen the 2 screws that secure the lamp cover, and remove the cover.
3
Loosen the 2 screws that secure the lamp.
4
Pull up the lamp by its metal handle.
5
Reverse steps 1 through 5 to install the new
6
lamp.
Reset the lamp by usage time selecting the left
7
Lamp Reset icon in the OSD Management tab.
NOTE:
Dell may require that lamps replaced
under warranty be returned to Dell.
Otherwise, contact your local waste disposal
agency for the address of the nearest
deposit site.
NOTE:
The lamp contains mercury. Disposal
of this material may be regulated due to
environmental considerations. For disposal
or recycling information, please contact your
local authorities or the Electronic Industries
Alliance: www.eiae.org.
26
Troubleshooting Your Projector
http://www.pureglare.com.au

Advertisement

Chapters

Table of Contents

   Related Manuals for Dell 1100MP

Comments to this Manuals

Symbols: 0
Latest comments: