Download  Print this page

Changing The Lamp - Dell S300wi User Manual

Hide thumbs

Advertisement

Table of Contents

Changing the Lamp

CAUTION:
Before you begin any of the procedures in this section, follow the
Safety Instructions as described on page 9.
Replace the lamp when the message "
on the screen. If this problem persists after replacing the lamp, contact Dell™. For
more information, see Contacting Dell™on page 119.
CAUTION:
Use an original lamp to ensure safe and optimal working condition
of your projector.
CAUTION:
The lamp becomes very hot when in use. Do not attempt to replace
the lamp until the projector has been allowed to cool down for at least 30
minutes.
CAUTION:
Do not touch the bulb or the lamp glass at any time. Projector
lamps are very fragile and may shatter if touched. The shattered glass pieces
are sharp and can cause injury.
CAUTION:
If the lamp shatters, remove all broken pieces from the projector
and dispose or recycle according to state, local, or federal law. For more
information see www.dell.com/hg.
Turn off the projector and disconnect the power cord.
1
Let the projector cool for at least 30 minutes.
2
Loosen the two screws that secure the
3
lamp cover, and remove the cover.
Loosen the two screws that secure the
4
lamp.
Pull the lamp up by its metal handle.
5
NOTE:
Dell™ may require lamps
replaced under warranty to be returned
to Dell™. Otherwise, contact your local
waste disposal agency for the address
of the nearest deposit site.
Replace with the new lamp.
6
Tighten the two screws that secure the
7
lamp.
Replace the lamp cover and tighten the
8
two screws.
Troubleshooting Your Projector
" appears
111

Advertisement

Table of Contents

   Also See for Dell S300wi

   Related Manuals for Dell S300wi

Comments to this Manuals

Symbols: 0
Latest comments: