Advertisement
@2012.11-V1.1
■ Installation Instructions
1、 Wheels Installation
Take out the Water Tank from the box, overturn it, and then fasten the 4 wheels on the
corresponding position with 16 sets of M8X16 Hex Head Cap Screw, spring washer and flat
washer. (Picture 1)
When using " automatic adding water", please take off the cover, then fix the weaved pipe.
When the weaved pipe is apart from the water supply, please screw on the choke plug so as to
avoid water leakage.
Cover
Remarks: As the Water Tank is very heavy, please be careful to avoid scratches of Water
Tank or hurt of the assemblers.
2、Fasten the Submersible Pump and Level Sensor
Turn the Water Tank with installed wheels back, and fasten the Submersible Pump and
Level Sensor inside the Water Tank. (see Picture 2)
Remarks: Put the Submersible Pump into the corresponding trench and press it. It will be
Aviator X2
Nut
Picture 2
Page 5 of 15
choke plug
Picture 1
Make sure the
water inlet is not
shielded.
Rubber Ring
Bottom of
water tank
Hide quick links:
Advertisement
