Table of Contents
Advertisement
Setting an indoor unit address and installation option
AA
Setting an indoor unit installation option (suitable for the condition of each installation location)
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power supply in the indoor unit.
2. The panel(display ) should be connected to an indoor unit to receive option.
3. Set the installation option according to the installation condition of an air conditioner.
- The default setting of an indoor unit installation option is "02000-100000-200000-300000".
- Individual control of a remote controller(SEG20) is the function that controls an indoor unit individually when there is
more than one indoor unit.
- No need to assign SEG3, 6, 9, 10, 11, 16, 21, 22, 23, 24 which are non applicable. Even though those segments are set,
they will be ignored.
- If you set the applicable segments with numbers other than the indiciated, the initial setting will be maintained.
4. Set the indoor unit option by wireless remote controller.
Option No. : 02XXXX-1XXXXX-2XXXXX-3XXXXX
Option
Indication Details Indication Details
Indication
and
0
Details
Option
Indication Details
Indication
and
1
Details
Option
Indication Details Indication Details Indication Details
Indication
and
2
Details
18
2
Setting the output
control
of external control
Thermo
0
Disuse
0
1
Control
Operation
1
OFF
2
Control
temperature sensor
Indication Details Indication Details
0
Disuse
1
Indication Details
on
on
control
0
Disuse
1
Indication Details
0
slave
1
master
0
1
Advertisement
Table of Contents
