KEEWAY RKV125 Instruction And Maintenance Manual page 90

Screw off braking cylinder assembly mounting bolt.
Remove the braking cylinder assembly from front shock absorber.
Remove front shaft.
Remove front wheel.
Remove brake disc from the front wheel.
5.3.2 Inspection
Check if braking shoe assembly and brake disc are worn. Replace them if necessary.
Measure braking shoe and brake disc and record the maximum values.
Specifications
KW125 Front brake disc diameter
Front brake disc thickness
* Attention
• Micrometer shall be used for the measurement.
Measure the thickness of braking shoe.
If brake disc and braking shoe are contaminated by grease or
their thickness is smaller than service limit, replace them.
Service limit: Braking shoe: 3mm
Brake disc:
Note:
Braking shoes shall be replaced in pairs.
5.3.3 Installation
Install brake disc and front wheel.
Install front brake hose assembly and brake cylinder assembly.
Please do not contaminate braking shoe and brake disc with oil.
* Attention
A contaminated braking shoe will reduce braking performance and result in brake failure.
Tighten bolt and nut to their specified torque value.
Torque value:
Oil pump block assembly mounting bolt
Front brake cylinder assembly mounting bolt
Do not contaminate braking shoe with oil.
If a braking shoe is polluted by oil, clean it with brake cleaner.
*Attention
φ260mm
4.0mm
3mm
5-9
22-29
N· m
N· m