KEEWAY RKV125 Instruction And Maintenance Manual page 9

Slack cable implies potential safety hazard on electrics. Check
the next cable when the cable is clamped to ensure electric safety;
Cable clamp shall not be bent towards solder joint;
Tie the cable at appointed position;
Do not lay the cable at the end of frame or at the closed angle;
Do not lay the cable at the end of a bolt or screw;
Wiring of cable shall be away from heat source or places where
cable may be clipped while moving;
Prevent the cable from being pulled too tightly or slacking too
much when the cable is wired along the handle pipe. The cable
shall not be affected by any neighbored components at any
turning position;
The cable shall be wired smoothly and shall not be knotted or
twisted;
Check if the sheath of connector is damaged and if the connector
is over stretched before butt joint connection;
If cable runs around the closed angle or the corner, please protect
it with tape or hose;
Tie the cable with adhesive tape reliably when it is repaired;
The controlling cable shall not be bent or twisted. Broken
controlling cable will result in non-flexible control.