Advertisement
goes out due to lack of oxygen or for any other reason.
If this device starts to repeatedly shut off the gas, get expert advice.
This device incorporates a probe that senses that the heat from the pilot flame is correct.
If this probe is cool, the device will prevent any gas flow unless the control knob is held
in at the ignition position.
If, for any reason, the flames go out when the fire is hot or if the fire is turned off when
hot, always wait at least three minutes before attempting to relight.
To light the fire.
Depress the control knob and rotate it
anticlockwise to the pilot ignition position. A
'click' will be heard as the integral piezo
operates. A flame should appear at the pilot.
Keep the control knob depressed and hold the
pilot ignition position for five seconds. When
the control knob is released the pilot flame
should remain lit. If a flame does not appear at
the pilot then turn the control knob clockwise
to the 'OFF' position and repeat the above.
When the pilot burner is operating properly,
gradually turn the control knob anti-clockwise
to 'HIGH' position. (Depress the knob slightly to get past the pilot ignition position).
The main burner should now light.
Depress the control knob slightly to release from the 'HIGH' position and turn back
(clockwise) to 'LOW'. While turning, the burner flames should gradually become lower
but remain alight. Depress the control knob slightly to release from the 'LOW' position
and turn back (clockwise) to the Pilot ignition position. The main burner should
extinguish but the pilot should remain alight. Depress the control knob slightly and turn
back (clockwise) to turn OFF. This will extinguish the pilot.
While cooling, the ceramic fuel effect may make some crackling noises. This is quite
normal.
If the flames go out while setting the control, repeat the full lighting procedure.
!
If the flames repeatedly go out have the fire serviced.
!
Please note. When first turned on the flames will appear predominantly blue. The
!
ceramic fuel effect will take time to warm up. Although some glow will be seen after
approximately ten minutes, the full visual effect will only be apparent after a somewhat
longer time.
The appliance will operate to its maximum potential if the flue is primed during the
!
first 20 – 30 minutes of operation. To do this, simply turn the control knob to its
OWNER GUIDE
Page 7
Figure 2. Lighting the fire
Advertisement
