5-2. Steps to take in an emergency
Stowing the flat tire, jack and all tools
Remove the center wheel ornament by pushing from the
reverse side.
Lay down the tire with the outer side facing up, and install the
holding bracket.
Then secure the tire, taking care that the tire goes straight up
without catching on any other part, to prevent it from flying for-
ward during a collision or sudden braking.
Keep winding until three clicks are heard.
Stow the tools and jack securely.
■
After completing the tire change
The tire pressure warning system must be reset. (→P. 543)
■
When using the temporary spare tire
As the temporary spare tire is not equipped with the tire pressure warn-
ing valve and transmitter, low inflation pressure of the spare tire will not
be warned. Also, if you replace the temporary spare tire after the tire
pressure warning light comes on, the light remains on.
620
Tightening torque
Flat washer type (Aluminum
wheels)
97 ft·lbf (131 N·m, 13.4 kgf·m)
Taper type (Steel wheels)
154 ft·lbf (209 N·m, 21.3
kgf·m)
*
: When temporarily used on
spare tire/wheel, apply 154
ft·lbf (209 N·m, 21.3 kgf·m)
I n f o r ma t i o n P r o v i d e d b y :
*