Toyota Tundra Quick Reference Manual page 526

Repeat the steps above to program another device for each of
the remaining HomeLink
■
Programming a Rolling Code system (for U.S.A. owners)
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink
steps listed below.
Locate the training button on the ceiling mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
Press the training button.
Following this step, you have 30 seconds in which to initiate step 3
below.
Press and release the vehicle's programmed HomeLink
ton twice. The garage door may open.
If the garage door opens, the programming process is complete. If
the door does not open, press and release the button a third time.
This third press and release will complete the programming process
by opening the garage door.
The ceiling mounted garage door opener motor should now recog-
nize the HomeLink
Repeat the steps above to program another rolling code sys-
tem for any of the remaining HomeLink
■
Programming an entry gate (for U.S.A. owners)/Programming
all devices in the Canadian market
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the
surface of the HomeLink
Keep the indicator on the HomeLink
Press and hold the selected HomeLink
Repeatedly press and release (cycle) the device's remote
control button for two seconds each until step 4 is complete.
®
buttons.
®
transceiver and operate the garage door.
®
.
I n f o r ma t i o n P r o v i d e d b y :
3-8. Other interior features
®
" before proceeding with the
®
buttons.
®
in view while programming.
®
button.
3
®
but-
503