Pro1 IAQ T925 Installation Manual page 8

Tech Setup Steps (Continued from the previous page)
Contractor Beep
Call Number
Allows you to put your When any key is
phone number in the
pressed an audible
display. beep will sound.
There is an ON
Select ON to use this or an OFF.
feature then press
NEXT STEP.
LCD Will Show
Adjustment Options
Use the or If ON is selected the
key to move from one beep will sound.
character to another.
If OFF is selected,
Use the or there is no sound.
key to change the
flashing character to
your desired number.
Factory Default Settings
OFF ON
If Contractor Call Number is selected ON, your phone number
Note:
will show in the display if there has been a continuous call for heating
or cooling for 24 hours or if the light button is held down for 3 seconds.
To remove the phone number from the display, hold the light button
down for 3 seconds.
System Gas Auxiliary
Switch for Heat Pump
You can configure the If Emergency Heat is
system switch for the seleted ON you will
particular application: see this option.
ON will turn off the
Heat 1st stage of heat 45
Off seconds after the
Cool second stage turns on.
Em Heat
or
Heat
Off
Cool
Auto
Em Heat
For heat pump
Use the or
systems that are
key until the desired
"dual fuel" (use a
application is
gas furnace for
flashing.
second stage heat)
you can turn this
feature on to turn off
the heat pump when
the second stage of
heating has been
called for.
Heat - Off - Cool
OFF
TECHNICIAN SETUP MENU
8