Power Wheels Jeep Wrangler Owner's Manual page 18

25
Seat Back Tab
Slot
• With the seat at an angle, insert the tabs on the front
edge of the seat into the slots in the foot-well wall
• Push down firmly on the edge of the seat above each
tab to insert and "snap" the tabs into the slots
• Rotate the back of the seat down
the seat back tabs into the slots in the vehicle body. Push
down firmly on the seat back.
26
• Insert a #8 x 1" screw through the hole in the rear of seat
and into the vehicle body, as shown.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
Assembly
Seat
2
PUSH
HERE
1
Tabs
1
Tabs
.
to insert and "snap"
27
Sport Bar
.
• Position the sport bar on its side so that the sport bar
ends curve away from you.
• Position the canopy opposite the sport bar with the
netting facing away from you.
• Slide the four canopy sleeves onto the sport bar.
28
• Extend the canopy completely around the sport bar.
18
Canopy Sleeves
Canopy
Sport Bar
Canopy
Canopy
Sleeves