Power Wheels Jeep Wrangler Owner's Manual page 15

13
Wide Tab
Wide
Notch
Lens
Guard
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
14
Slot
Tab
• Fit the tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to "snap" the lens assembly into the grille.
• Repeat this procedure to assemble the other lens
assembly into the grille.
Headlight
Lens
Grille
Assembly
15
Front Bumper
• Fit and hold the brush guard against the front bumper.
• Insert two #10 x 1" screws through the front of the brush
guard and into the front bumper.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
16
• Fit a spacer tube between the grille and the
back of the brush guard, as shown.
• Insert a #8 x 4" screw through the brush
guard, spacer tube and into the hole in
the grille.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to assemble the other
spacer tube and #8 x 4" screw to the other
side of the grille.
15
Brush Guard
Spacer
Tube