Table of Contents
Advertisement
Chapter 2. Setting up the projector
This chapter provides information on positioning the projector, connecting a
computer source and displaying and adjusting an image.
Starting the projector
To start the projector, do the following.
1. Connect the power cord to the projector as shown below. Connect the other
2. Remove the lens cover.
3. Attach any wired input devices.
4. Turn on the connected input devices. For more information, go to"Connecting
5. Be sure that the Power LED lights steady (not flashing) amber and then press
© Lenovo 2005. Portions © IBM Corp. 2004.
end of the cord to an electrical outlet. The Power and Lamp-ready LEDs turn
on.
devices" on page 4-1
the Power button to turn on the projector.
The projector display window opens and the projector detects connected
devices. If you are connecting wirelessly, go to Chapter 3.
If you connected the projector to a ThinkPad
computer to switch the display output to the projector. If you connected the
projector to a non-ThinkPad computer, refer to the documentation that came
with your computer for information on how to change the display output.
®
computer, press Fn+F7 on the
2-1
Advertisement
Table of Contents
