Clear Malfunction - Ten-Haaft Oyster SAT-DOM 50 ST Operating Instructions Manual

Clear malfunction:

symptoms
No function and no positioning noise
Continuous positioning noise. No reception.
Antenna has positioned, no further adjusting
noise, but no reception:
Sudden Interruption of the TV signal
Breakdown of the TV signal. Noise of motion
continuously inside the DOM
Others
error cause
– Proof the power supply
- Power module connected? 11-28 V/DC or by
power supply unit 230V /AC.
- SAT receiver switched on?
- SAT connection cable linked properly?
– On the fi rst initialization, the adaptation of the
system may take a while. The system needs to
adjust to the new location
- Prevents a build-up or an other obstacle the
reception? Corrective -> change position
- Verify the confi guration of the receiver, switch
channel
- Proof the connection between TV and receiver
- An obstacle in the reception line for a short
time. The Antenna fi nds immediately again the
satellite position again (GS / M-GS)
- Verify the power supply
Separate the receiver and the POWER-MODUL
from the power supply. Wait a minute and recon-
nect the connections again.
- Radar or airport near
- Mechanical damage is sometimes not visible
from outside. The dome is made out of fl exible
material.
11