Dimensions; Packing And Transport; Stickers For Instruction And Safety - Benassi BL 6000 Instruction Manual

SpA
DIMENSIONS
The dimensions of the tiller are shown in picture 3.
Fig. 3
◊
Length: 80 cm.
◊
Width: 50 cm.
◊
Height: 70 cm.
•
Take the machine out of the carton box.
•
Fit the two tilling units to the main shaft using the delivered pins already assembled on the tilling units.
•
Fit the arm with spur in its place using the delivered pin.
•
Fix the handlebar to the handlebar support using the parts already assembled on the handlebar support
itself.
•
The small wheel holder is fitted to the frame by means of a screw nut and a splint pin.
•
Fit the two guard‐extensions to the main tiller protections fitted on the body of the machine using the
proper screws and nuts. The protection guards should reach a width of 60 cm according to the CE
requirements.
•
During the transport the handle can be left unassembled by means of the threaded bush that fix it to the
handlebar support. The tiller is equipped with a front handle (see Pict.4 Ref. "A") in order to be able to
lift and to transport the machine easily.
Please find here below the stickers put on the machine. It is very important that they are always clearly legible to prevent any accident.
1)
4)
R· 2· 0· 1
7)
In case the stickers are damaged it is absolutely necessary to replace them by ordering the original spare parts.
4
600
800
PACKING AND TRANSPORT
STICKERS FOR INSTRUCTION AND SAFETY
2)
5)
8)
1660
3)
6)
9)
BL 6000
Fig. 4
A
BL 6000