Key To Machine Parts; Identifications And Technical Specifications; Ce Mark; Tilling Units - Benassi BL 6000 Instruction Manual

SpA
1‐ Transport wheel
2‐ Engine oil cap
3‐ Tillers
4‐ Tiller protection
5‐ Braking spur
6‐ Belt cover
7‐ Gear lever
8‐ Clutch lever
9‐ Throttle lever
10‐ Handlebar adjustment
11‐ Fuel tank cap
12‐ Handle
13‐ Recoil starter
14‐ Choke lever
15‐ Air cleaner
IDENTIFICATION AND TECHNICAL SPECIFICATIONS
ATTENTION: FOR THE ENGINE TECHNICAL SPECIFICATIONS, SEE THE ENCLOSED OWNER'S MANUAL OF THE ENGINE.
•
Acoustic power level LwA = from 92 dB (A) to 105 dB (A)
•
Noise level at operator's ear : LpA = from 81 dB (A) to 90 dB
(A)
•
Test condition: 1,6 mt at the centre of the handlebar
•
Handlebar vibration according to ISO 1033: value from 4,76
m/sec² to 7,00 m/sec²
CHARACTERISTICS OF ALL THE ENGINES FITTED:
•
Exhaust guard
•
Recoil starter
•
ENGINE LUBRICATION: see the owner's manual of the engine
•
Engine oil quantity: see the owner's manual of the engine
•
Engine fuel: unleaded petrol
•
Safety device for both forward and backward gear stopping
the tiller.
•
The gear has got two forward speeds and one reverse, a belt
joins the transmission to the engine and an oiled chain to
the tiller.
SPECIFICATIONS WITH ENGINE RUNNING AT 3200 RPM
I forward = 82 rpm
II forward = 113 rpm
Reverse = 61 rpm
•
Speed gear in oil bath
•
Belt clutch with tightener
•
Tiller with hexagonal shaft and reinforced blades
TILLING UNITS:
The blades are adjustable and provided with a protection mudguard. In picture number 2 you can see the possible working width: 60 –
80 cm with the extensions and the side plates fitted.
KEY TO MACHINE PARTS
HONDA
15
14
13 15
KIPOR
11
13 14
12
1
2
•
Guidance handlebars can be adjusted in many positions (ver‐
tical and side adjustment).
•
The tiller is 80 cm wide.
•
The spur is adjustable
APPLICABLE ACCESSORIES
•
Ridger with attachment
•
Thin iron wheels (Ø 320) are suitable when using the ridger
CE MARK
To identify the machine (serial number, engine, weight, power)
have a look at the number plate put on the machine as in (Pic‐
ture 1 Ref. "A").
Fig. 1
Fig. 2
BL 6000
10
3
A
800
9 8
7
6
5
4
3