Table of Contents
Advertisement
Table 25. Removal steps of DC-in cable and base cover assembly
Note: Applying labels to the base cover
Note: If the Windows Authentication label (COA)
with the label attached to the customer, or provide a letter to the customer stating what the label was
originally on the system and what the label part number, serial number, and product key were.
The new base cover FRU is shipped with a kit containing labels of several kinds. When you replace the
base cover, you need to apply the following labels:
2
SIM information label under door
3
Information label under door
5
Certified label under battery
Following labels need to be peeled off from the old base cover, and need to be put on the new base cover.
1
Windows license label (COA) (only for Windows 7 models)
4
Ethernet label
For some models, you also need to apply one or two FCC labels. Check the old base cover; if it has one or
two FCC labels, find duplicates of them in the label kit and apply them to the new base cover.
For the location of each label, refer the following figure:
86
ThinkPad Edge 11" and E10 Hardware Maintenance Manual
1
3
3
is attached to a part that is replaced, return the old part
2
Advertisement
Table of Contents
