Canon HV10 Instruction Manual page 76

Trouble? •••••- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Printing
Problem
The printer is not operating
even though the camcorder
and printer are correctly
connected.
Editing
Solution
Disconnect the USB cable and turn off the camcorder and the
printer. After a short while, turn them on again, set the
camcorder to
(PLAY:!:]>I
mode and restore the connection.
OJ
Problem
Solution OJ
Cannot record with this Set [AV .. DV] to [OFF].
33
camcorder video input from an
Wrong signal standard. Dubbing may work using the AV IN/OUT -
external video device
terminal.
connected to the HDV/TV
Refer also to the instruction manual of the connected device.
terminal using a DV cable.
Others
Problem
A rattling can be heard from the
camcorder.
List of Messages
Solution
The internal lens fixture can move when the camcorder is turned
off: This is not a malfunction.
OJ
Message Explanation/Solution OJ
SET THE TIME ZONE, You have not set the time zone, date and time. This message
24
DATE AND TIME
appears each time you turn the power on until you set the time
zone, date and time.
CHANGE THE BATTERY Battery pack is exhausted. Replace or charge the battery pack.
18
PACK
THE TAPE IS SET FOR Cassette is protected. Replace the cassette or change the position 80
ERASURE PREVENTION of the protect switch.
REMOVE THE CASSETTE
Camcorder stopped operating to protect the tape. Remove the 19
cassette and reinsert it.
CHECK THE HDV/DV
The DV cable is not correctly connected to the HDV/DV terminal, or 57
INPUT the connected digital device is turned off.
(Appears only
if
a DV cable is
The video input signal is in a different television system (PAL or
-
connected)
SECAM).
CONDENSATION HAS Condensation has been detected in the camcorder. 82
BEEN DETECTED
CONDENSATION HAS
Condensation has been detected in the camcorder. Remove the 82
BEEN DETECTED cassette.
REMOVE THE CASSETTE
TAPE END
Tape reached the end. Rewind the tape or replace the cassette. -